Would be 5 stars if it didn’t weigh so much. A lightweight version would be rad

I have the STS Buttstock and while it is not listed as compatible, it actually is. I called MDT technical assistance before ordering and they were very helpful.
Installed it on my STS Buttstock with no problems.

Great product

Attached this to my HNT26 on my 300PRC. This helped me adjust my butt to my shoulder while maintaining my cheek weld. Awesome!!!!

This really makes the stock fit right! It should be a included with the price of the mdt stock purchase, not a add on.

Perfect. I wish I had known about the pad earlier.

Excellent fit and finish and an easy install. It does what it is advertised to do. Can't ask for much more than that.

Great addition to both of my MDT chassis! I found a supplier for brass adjustment knobs, giving them a classier look.

Nice addition to my SRS stock. Fitment is perfect. Ability to fit stock to shoulder connection is huge. Fit was good before, now it's even better. It's a win in my book.

Awesome

This butt pad allows for better fitment to the shoulder. There are both adjustments for can't as well as elevation to allow for a more centered placement of the rifle.

Works great

I have not tried it since this build was for my wife. However, it went right on and my wife like the ease of use.

Excellent product. Fit and finish is top notch.

Very nice adjustments. Makes eye relief consistent from prone to seated. Mounting screws provided were too long.

Having a buttpad that is adjustable is a huge plus! This one is something I’ll be buying again.

If you adjust incorrectly a seriously sharp edge presents itself. Other than that it’s as expected.

This is a solid well made but pad I use this primarily on my hunt 26 long action while doing load development and is not so heavy that you can use it on a hunting rig. I do recommend this product

Working on managing recoil on my +/- 8.5 lb hunting rifle and getting the support at the shoulder a little higher up at the stock and more in line with the bore helps a lot. Definitely worth the trade of in the little bit of extra weight. Another great MDT product!

Fits XRS chassis perfectly. Great for precise adjustments.

The adjust buttons has made an improvement to my groupings. Loving MDT products and my chassis build. Thanks MDT!

Great fit just what I needed

Very easy to install and they sent screws with it for adjusting. My stock now fits me much better.

Great product, Easy install, reliable customer/ company. Would highly recommend to all my friends.

I'm going to purchase a few more for my other MDT chassis. It works well for prone shooting and seated.

Very nice and well made. Works great.

Does exactly what it’s supposed to. Fits great. Works great.

Works great!

Exceptional buttpad…..just need a few instructions to go with it. Moves very well in all of the right directions. A necessity for the Oryx Chassis IMO. Be careful not to over tighten the aluminum block as you can pull out the screw retainers….I did…..and MDT sent me a new polymer insert….again great customer service from MDT!!!!

Original butt pad was torn on the bottom corner. Perfect replacement for original.

Works awesome. A important piece of the puzzle for an optimized rifle. Would recommend.

Perfect for two shooters sharing the same weapon (Dad/ Daughter) to get the best fit for both shooters.

DOn't hesitate to buy. It is a great addition and it will take the fit of you chassis to a whole new level.